I am new to MainLobby.
I installed the MLLighting and UPB plugins. That went OK. The UPB plugin could connect to my UPB CIM but it reported the network ID as 255 when it is in fact 128. If I change (in the plugin) the network ID to 128 it says it has to reprogram all devices (which are already correctly setup using UPStart).
Any attempt by the plugin to connect to any of my UPB devices fails, I assume because the plugin is using the network ID of 255.
What am I doing wrong?
BTW the plugin did not recognize the following keypad device: HAI Part Number: 38A00-1
2 posts • Page 1 of 1
- Posts: 253
- Joined: Sun Apr 04, 2004 4:22 pm
Who is online
Users browsing this forum: No registered users and 1 guest