Elk M1 Plugin 1.3.24

User avatar
ladiaz
New Member
New Member
Posts: 46
Joined: Sun Feb 08, 2004 1:57 pm
Contact:

Elk M1 Plugin 1.3.24

Postby ladiaz » Mon Nov 06, 2006 10:55 pm

Has anybody installed this update? I re-downloaded my software from the site and this version was downloaded. However, when I when to activate, it states I have an invalid license key. The previous versions did not use the license key, only an activation code. Can someone elaborate on this issue?

User avatar
gregoryx
Simply Incredible
Simply Incredible
Posts: 6599
Joined: Tue Sep 30, 2003 10:15 pm
Location: Newport Beach, CA
Contact:

Postby gregoryx » Mon Nov 06, 2006 11:23 pm

Still shows "1.3.16" for me.

User avatar
ladiaz
New Member
New Member
Posts: 46
Joined: Sun Feb 08, 2004 1:57 pm
Contact:

Postby ladiaz » Sat Nov 11, 2006 11:52 pm

Has anyone else run into this? I have reverted back to 1.3.16 since 1.3.24 didn't work. If this is the upgrade to the plugin, someone should look at the registration code since it is different that the previous versions where only and activation code was required.

User avatar
DavidL
Simply Incredible
Simply Incredible
Posts: 11071
Joined: Sat Feb 08, 2003 9:39 am
Location: Metamora, Michigan
Contact:

Postby DavidL » Sun Nov 12, 2006 12:10 am

ladiaz, The elk plugin (like many others) has been updated for the latest license / registration. If you purchased the ELK plugin in the past, just send an email to Dave@cinemaronline.com w/ your old license key and dave will invalidate the old and email you a new license code. After licensing, you just Activate it (see MLServer User's guide for details).

majeds
Newbie
Newbie
Posts: 10
Joined: Fri Oct 27, 2006 8:41 am
Contact:

Postby majeds » Tue Nov 21, 2006 9:51 am

I just reactivated the new version and it says "permanent". However, the server variables dare not created in MLServer. I checked the configuration of the the plug-in and it is the same as before. Any clue?

User avatar
ladiaz
New Member
New Member
Posts: 46
Joined: Sun Feb 08, 2004 1:57 pm
Contact:

Postby ladiaz » Tue Nov 21, 2006 11:02 am

I'm having the same problem, the plugin in now longer responding to commands from any of my clients. I turned on the logging, and I don't get anything at all in the logs but Thermostat/PLC events(none of the typical Ethernet Heartbeat messages you normally see)


Return to “Elk Products”

Who is online

Users browsing this forum: No registered users and 1 guest