How are people arming their alarm from cinemar.
I set up a code in the elk that only has arm user authorization. When I send a command
MLELKM1|Arm~1~1~code it arms the system.
If I send the same command again it disarms the system even though I don't have DISARM setup as a user authorization for that code. Very confusing. If I remove ARM authorization for the user then it obviously won't do either arm or disarm.
I also tried to use the virtual keyboard command to enter a code to disarm the system using
I don't see anything happening with the key commands. I tried doing an KEYINIT first and that didn't help.
I get all the status vars fine and I can arm and disarm with the ELK virtual keypad.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest