Arm / Disarm status

bigDvette
Expert
Expert
Posts: 718
Joined: Thu Oct 12, 2006 12:19 pm
Contact:

Arm / Disarm status

Postby bigDvette » Wed Mar 09, 2011 3:56 pm

How are people arming their alarm from cinemar.

I set up a code in the elk that only has arm user authorization. When I send a command

MLELKM1|Arm~1~1~code it arms the system.

If I send the same command again it disarms the system even though I don't have DISARM setup as a user authorization for that code. Very confusing. If I remove ARM authorization for the user then it obviously won't do either arm or disarm.

I also tried to use the virtual keyboard command to enter a code to disarm the system using

MLELKM1|Key~#

I don't see anything happening with the key commands. I tried doing an KEYINIT first and that didn't help.

I get all the status vars fine and I can arm and disarm with the ELK virtual keypad.

Any suggestions?

bigDvette
Expert
Expert
Posts: 718
Joined: Thu Oct 12, 2006 12:19 pm
Contact:

Re: Arm / Disarm status

Postby bigDvette » Fri Mar 11, 2011 3:23 pm

Anyone?


Return to “Elk Products”

Who is online

Users browsing this forum: No registered users and 1 guest