I see on the wiki the following command (MLServeCmd.MLELKM1|RLD~LogEntry) that I assume writes the M1's log to a variable, but I can not seem to find it.
My end goal is to display the event log on a web interface since while I was out of the country this past week, my alarm went off, and I didn't know why. I might also want to automatically send the log via an email so that the information could get to my cell phone automatically.
Any assistance would be greatly appreciated!
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests