Displaying System Log

Bago
Intermediate
Intermediate
Posts: 452
Joined: Mon Dec 29, 2003 3:02 pm
Location: Potomac, Maryland
Contact:

Displaying System Log

Postby Bago » Sun Mar 07, 2010 9:50 pm

I see on the wiki the following command (MLServeCmd.MLELKM1|RLD~LogEntry) that I assume writes the M1's log to a variable, but I can not seem to find it.

My end goal is to display the event log on a web interface since while I was out of the country this past week, my alarm went off, and I didn't know why. I might also want to automatically send the log via an email so that the information could get to my cell phone automatically.

Any assistance would be greatly appreciated!

Barry

Bago
Intermediate
Intermediate
Posts: 452
Joined: Mon Dec 29, 2003 3:02 pm
Location: Potomac, Maryland
Contact:

Re: Displaying System Log

Postby Bago » Sun Mar 14, 2010 9:26 am

bump


Return to “Elk Products”

Who is online

Users browsing this forum: No registered users and 1 guest