ELK COMMANDS

Art Dustman
Expert
Expert
Posts: 576
Joined: Fri Nov 10, 2006 3:22 pm
Location: NJ
Contact:

ELK COMMANDS

Postby Art Dustman » Sun Jan 17, 2010 4:52 pm

I had to change the default increase heat setpoint command because pressing the "up" arrow did nothing. I am sending the server command: MLELKM1|HSPINC~1 to increase the setpoint 1 degree. On screen the number now increments, but the stat does nothing. Any ideas?

My default 019 screens are all seeing the current temperature from the stat, so comms is good i think...

Art

killervette
Senior Member
Senior Member
Posts: 136
Joined: Tue Sep 15, 2009 7:42 am
Contact:

Re: ELK COMMANDS

Postby killervette » Sun Jan 17, 2010 9:29 pm

Art Dustman wrote:I had to change the default increase heat setpoint command because pressing the "up" arrow did nothing. I am sending the server command: MLELKM1|HSPINC~1 to increase the setpoint 1 degree. On screen the number now increments, but the stat does nothing. Any ideas?

My default 019 screens are all seeing the current temperature from the stat, so comms is good i think...

Art


I have had trouble with elk and my temps from day one. It will show the correct temp, but when i increase by 1 it will either not change or increase by 2.


Return to “Elk Products”

Who is online

Users browsing this forum: No registered users and 1 guest