3 posts • Page 1 of 1
- Senior Member
- Posts: 134
- Joined: Sat Oct 25, 2008 11:13 am
I'm trying to view/edit the properties of a sensor and I can't get access to the Commands on CLOSE or Commands on OPEN text field after it's defined. When I defined the sensor I was able to type into the text field for these commands, but now it's not available. Is there some other key sequence that will make the fields available?
You do not have the required permissions to view the files attached to this post.
- Site Admin
- Posts: 10535
- Joined: Fri Feb 07, 2003 8:56 am
- Location: Planet Earth
You found a little "feature". If the object was set as a relay and saved then it hides those fields since there are no on and off events. However, once they were hidden they never came back. The version of MLGC that I just released will fix that.
Who is online
Users browsing this forum: No registered users and 1 guest