SetVolume Command Powers on the CAV Zone

User avatar
ccarpenter1
Member
Member
Posts: 74
Joined: Sun Dec 10, 2006 7:49 pm
Contact:

SetVolume Command Powers on the CAV Zone

Postby ccarpenter1 » Tue Dec 09, 2008 8:30 am

I have really been struggling with this for the last two days.

After a lot of debugging, I found that the following command
MLServeCmd.MLCAV66|SetVolume~1~3~80

actually powers on the zone as wel as set the volume.

The problem I was having was that I had a routine where I was restoring the last zone, last volume, and powering off the zone. Since I had the "power off the zone" as the first in my code sequence, the zone would power off and then immediately power back on because of the SetVolume command.

If this the default behavior of the CAV? Is there a way to change this?

Thanks!
Chuck

Return to “Russound”

Who is online

Users browsing this forum: No registered users and 1 guest